When fishing, especially for walleye, the biggest fear is to fall off the chain at a critical moment, just slipping up when snapping the rod. It's a lost cause!

Most of us usually blame objective factors or other people's factors when something goes wrong, and rarely look at ourselves. When a rod breaks, you should first check if your own operation is wrong, because rods have their own load-bearing limit, and if they are not operated properly, then of course the rod will break.

The same are with 1.0 line, but some people fishing bigger fish have no problem, while some people fishing not big fish will break, you may say is the quality of the line, or the relationship between the tuning of the rod, but the most important sea lion to do their own to do, to improve their fishing skills. The following is only for the reference of anglers:

1, the correct way to open the fishing rod

Fishing should be patient, eager to eat hot tofu, do not start to wait to pull out the fishing rod one section at a time as soon as you arrive at the fishing spot, because each fishing rod has a contact point of the upper and lower sections, just like a lock, used to fix the rod.

So you must know that when you open the rod, you should turn it to the right side after pulling it out to lock it in place. But don't make it too tight, then you won't be able to retract it. If you don't lock it like this, then it's very likely that you'll take it back in the process of fishing.

2, the line group should be matched scientifically

Speaking of which, everyone understands that the main line is larger than the subline, but how to match it is also a study. It is important to note that because of the different conditions in each area, the water conditions are also different, this time there is no alternative but to rely on their own experience.

If you just want to fish up to one catty, then you can choose a 1.0-0.6 or 0.4 line set. If you want to be bigger, for example, 10 pounds, you have to choose 3 + 2 or 1.5, if you are not sure of their own fishing techniques, you can lower the line set properly, sometimes it is necessary to do rather break the line than break the rod.

3, walk the fish to be correct

To ensure that the fish walk correctly, first you have to do not pull the river. So when casting the rod to pay attention to leave enough rich line. Otherwise you can only rely on pure brute force, which will trigger a very serious bad consequences is your line broken.

Sometimes because we cast too full, the rod will be pulled into a straight line, there is no borrowed power, the rod's elasticity did not play the role of unloading. If this is the case, it is not unusual for the fish to be cut.

So the correct way to slip the fish should be the fish hooked first stand up the rod, especially when we catch a big fish, this time the rod should have been in the 70 degrees or more, we should hold the rod with both hands tightly at the end of the rod, which makes the rod's whole body to play a role. Then one hand hand rod in the fish, because the rod after the fish will reflexively outward sprint, so our other hand to suddenly hold the handle of the upper middle, so as not to suddenly break the rod.

4、Receiving the rod should be careful

The more you get to the end, the more careful you have to be. Many people will break their rods at the end of the collection, which will waste all the efforts in front of them, and the duck to the mouth flew away. This happens because they are used to reeling in the rod first and then removing the main line, which is common, but also extremely wrong.

Because so many rods are made to not be head heavy, most of the first section of the rod is hollow. Therefore, when you receive the last section of the rod, you have to take the space bean and the main line. You must pay attention to the last step, and don't let go of the smallest detail, otherwise you will give up the previous work and get nothing.